Clean and prepare accessible steel.
Application solution
Bolts & Irregular Components
Profiling and wrapping systems for bolt clusters, supports, welds and steel details that are difficult to coat continuously.
Discuss This Application
Application challenge
Protection must follow the asset geometry and exposure
- Sharp transitions, gaps and small clearances interrupt conventional coating films.
- Irregular components often need adaptable protection without dismantling.
Typical industries
Steel structuresTank farmsIndustrial maintenanceRecommended system approach
A coordinated route from inspection to final protection
Final selection depends on the substrate, operating environment, geometry and approved application procedure.
Fill recesses and create a wrap-friendly profile.
Apply conformable corrosion protection tape.
Finish exposed surfaces with a matching outer layer where specified.
Installation sequence
Typical application process
This overview does not replace a product-specific method statement or site risk assessment.
- 1
Prepare the component
- 2
Fill gaps and recesses
- 3
Wrap all faces and transitions
- 4
Seal and inspect terminations
Before
DuringEngineering inquiry
Information that helps us review your requirement
- Asset type, dimensions and geometry
- Existing coating and corrosion condition
- Operating temperature and environment
- Surface preparation and access constraints
- Required technical or safety documents
Discuss the system with Zhuohuang
Our team can help identify candidate components and the documents needed for technical evaluation.
Start Application Inquiry